This summer I bought 3D printer!

3D printing is so much fun! I bought the Anycubic Vyper this summer and it has been great. I started searching STL files from Thingiverse and Printables and I found way to many great designs to focus on! Once I had downloaded about 300 stl's I figured out I needed a slicer to prepare the stl for the printer. so with a bit of googling I decided to try Cura Slicer. Learning to use Cura was not to complicated but I can tell it is till much more than I am using at this point! 

With the STL files I found processed by Cura slicer into .gcode files all that was left was the printing. Or so I thought...